Motion Alarm for Shed Security

We arrived at the camper Friday night, I did like I normally do, unlocked the shed and the boat lift so everything would be ready Saturday morning. Sometime Saturday we realized someone had stolen things out of the shed.

The biggest item was our Big Mable tube, which was inflated at the time. They also took a cordless drill, some swimming fins, a remote control boat, and even our fireworks.

We are not really sure if it was broken into during the week, or sometime during the early morning h0urs Saturday.

I now know we need some type of alarm inside the shed. Here is what I wanted.

• Ran off batteries, since shed power could be easily turned off by an intruder
• Was motion a motion sensing and did not require any major installation
• Alarm sets off very quickly once motion is detected.

Many of the more popular motion sensors on the market make no sense because once motion is detected it gives a warning beep and flash for 30 seconds! This gives away the location of the alarm, and also gives an intruder plenty of time to disable the alarm. Useless.

I finally found goes off right away, it only gives about a 5 seconds warning and a small led right light flashes (which can be easily hidden, or even covered with a piece of tape). It has 2 remote controls for arming and disarming. Also includes a wall mount bracket,  but it can also just be set in a corner somewhere.

I bought this motion alarm off amazon, actually was a 2 for 1 deal so I have 2 complete motion alarms and remotes,  so one will go in the shed, and one will go in the camper.

Here are some pictures of what you get with this motion alarm package.  For a cheap security system, you can’t beat it.

The back side of the package.

The alarm takes 4 AA batteries, or can use a 6 volt adapter. I like the battery option since it will work anywhere, and even if you lose power.

The alarm also has a “chime” mode which is for a store or business to alert when a customer walks in the door. Note: the remote does not arm/disarm the unit when in chime mode. The chime is actually quite loud.

The wall mount.

The remote control. (includes batteries)

Motion alarm setup with no installation (on a table)

This motion alarm is the perfect alarm for a shed or garage, the alarm is very loud, and it is really simple to setup and use.  I got 2 motion alarm units from Amazon for shipped for under $25.

(This model happens to be called “US Patrol”, but I see this same model sold under lots of different names.)

Motion Alarm Directions:

JB5532 2 in 1 Motion Sensor Alarm and Chime

Directions:

1. Set the switch on the main unit to Alarm or Chime mode as desired.
2. Insert four (4) AA batteries in the main unit (or use  a 6 volt adapter).
3. Once the batteries are inserted in the main unit, a light will appear in the red sensor cell indicating it is in standby mode.
4. Pull the plastic tab out of each of the remote control units to activate (3 button cell AG13 batteries included).
5. Point the remote control towards the main unit and push the button once.
6. The main unit will “beep” and a green light will appear for about 18 seconds allowing you to lock up and leave the room before it activates.
7. Once the green light disappears, the main unit is now in monitor mode.
8. A sound will go off if a person passes the main unit within 16 feet.

If the main unit is set to Chime mode, a “Ding Ding” sounds immediately.

If the main unit is set to Alarm mode, the red indicator light will blink and if the remote control is not presses within 5 seconds the Siren Alarm will sound. It will stop after about 45 seconds and return to “Monitor” mode.